Product Description
If you own a S&W V-Comp Revolver in any caliber we have the replacement sight for you.
Our Dove Tail Front Sights are 0.100" wide and have a red fiber dot of 0.075" diameter. Green fiber may be exchanged
These sights are direct replacements for the S&W factory sights.
You need to drive the old sight out and press the new on in. Some fitting may be required but typically not.
Note: We recommend that you drive the old sight out from right to left as you are looking down the barrel with the gun pointed away.
And the drive the new sight in from left to right. This keeps from passing the sight completely through the dove tail and loosening it up..
These are available in the following heights: 0.219", 0.249", 0.280" 0.312" and 0.352" The height is measured from the bottom of the sight base to the top.
All sight bases are 0.3750 at the widest part of the base and the base angle is approximately 45 degrees.
Product Videos
Custom Field
Product Reviews
18 Reviews Hide Reviews Show Reviews
-
Front Dovetail sight
Works beautifully on my Smith & Wesson 629 Competitor!
-
Better than Expected!!!
I was sceptical when I bought this sight. The fit and finish was better than the factory orange ramp sight on my 686 performance center. Install was easy and the brightness of the fiber optic is one of the best. Totally changed the look of my revolver. Way better than expected!!!
-
Dovetail Front Sight
Fit perfect!
-
S&W 986 Front Sight
Used this sight to replace a ramp front sight with an orange insert. That sight was OK, but I found that this type of sight was better in a wider range of lighting conditions. Tightened up my group in rapid fire.
-
Dove Tail Front Site review
Easy install. No fitting was required. Installed it in about 10 minutes using brass punch set. Faster target acquisition and much improved line of site. Aesthetically, my S&W 44 magnum V comp so sexy now! Highly recommend this product.
-
Dovetail sight
Fit perfectly. Made well. Very prompt!
-
S&W dovetail fiberoptic front sight
perfect fit on my snubnose performance center 629 and 627....my old eyes can see the front sight much much better and the quality is excellent
-
S&W 686 Competitor front sight
LPA sight from S&W was too low from factory. Replacement fiber optic from Revolver Supply was great, perfect fit and brought the impact down to the aim point. Thank you
-
A perfect replacement
If you have concerns about fit or finish of the Revolver Supply Co. replacement fiber optic dovetail front sight for S&W revolvers, .... rest easy! Following the instructions for direction of remove/install, this was a perfect retrofit to my 686+ 2 1/2" PC revolver. I used an aluminum drift and a polymer bench block and the result is exactly as I desired.
